Use the - and + buttons near the Buffer to configure the size of your available buffer in the game.
Use the - and + buttons near the Code Matrix to configure the size of the given Code Matrix in the game.
Click on the first empty cell and start selecting all the codes until the matrix is fully completed.
Add the sequences by clicking on the + button and then selecting the codes. Click Add for each sequence when completed.
Once everything is configured, use the Solve button to show the best solutions for this setup.
Notes
Depending on the parameters, there could be different solutions. In those cases, the best solution is presented first. Others can be viewed with the Prev and Next buttons.
When selecting codes for the Matrix or Sequences, hotkeys can also be used: 1 selects 1C, E selects E9... and so on. Del and Backspace remove the last code.
When adding Sequences, key Enter acts as the Add button, while key + adds the sequence but doesn't close the dialog so you can add another one.
C buttons clear all values, while R buttons randomize them.
When Play mode is selected, this page behaves like the game itself, and when in Edit mode it allows to modify the contents of the matrix. Mode can be switched temporary by holding the Shift key.
Note that when editing the matrix, Play mode will be automatically enabled once the matrix is complete, otherwise Edit mode will be selected.
Thanks
This page is 100% free, but if you like it you can support me:
Share this page in your Twitter, Facebook and other social networks so this reaches more people. It will cost you only one minute and will help me a lot!